ATLS ST-UV72 Model - HVAC Air Purifier  

• Kill 99.9% of airborne germs
• Air sanitizer
• Total home purifier
• Two 254nm Dual Tube lamps
• UVC Germicidal lamps​

 

1-Year Limited Manufacturer's Warranty

• 2 Pieces UV bulb
• Voltage (V): 110V to 220V
• 13000 hours Life of UV Bulb
•  Power (W): 72
• Kill almost 99.9% harmful bacteria
• HVAC systems and indoors
• 2400 sqft Effective area
• Diameter of UV Bulb: 17mm, length 411 mm
• Base: 254*160*56 mm
• Gross weight: 2.2 KG
• Net weight: 1.5 KG
• Kill 99.9% of the bacteria
• No ozone
• 254NM germicidal UVC 
• Installation takes less than 15 minutes​

1. Disconnect power to the HVAC system before installing the unit.
2. Need to create a template and tape it to the duct work in the intended installation position.
3. Drill pilot holes as required with a 3/32” drill bit.
4. Cut out the appropriate hole on the HVAC pannel.
5. Remove any burrs and be sure duct surface is flat after cutting the hole(s).
6. Install the bulb(s) in the unit by sliding the bulb in from the outside until the bulb snaps into place. Insert the unit into the metal duct cut out. If you touch the bulb with your hands, use a cloth to wipe any fingerprints from the bulb(s).
7. Attach the unit to duct work with the supplied 4 sheet metal screws using a ¼” nut driver. Make sure to tighten screws evenly. The unit has a factory installed gasket that ensures a tight seal between the unit and the duct work. Be sure the unit is flat against the duct work on all sides. CAUTION: DO NOT OVERTIGHTEN SCREWS.
8. Plug the unit into a grounded 120 volt power outlet.
9. Turn unit on and verify that the LED indicator light(s) located near the on/off switch is/are illuminated.
10. The switch is in the on position when the solid line on the switch is pressed down.
11. Reconnect the power to the HVAC system
12. The unit is now operational and does not need to be powered off unless cleaning or bulb replacement is necessary